NOKIAROM / FIRMWARE

Stock ROM for Nokia 7.2 DDV (TA-1178-1181-1193-1196)

Nokia 7.2 is powered by the Qualcomm SDM660 Snapdragon 660 Octa-core (4×2.2 GHz Kryo 260 + 4×1.8 GHz Kryo 260) processor. The smartphone comes with a 6.3 inches IPS LCD capacitive touchscreen. The screen of the device is protected by Corning Gorilla Glass 3.

The rear camera consists of a 48 MP (wide) + 8 MP (ultrawide) + 5 MP, depth sensor lenses.

The front camera has a 20 MP sensor. The phone’s sensors include Fingerprint (rear-mounted), accelerometer, gyro, proximity, and compass.

The smartphone is fueled by a Non-removable Li-Po 3500 mAh battery + Battery charging 10W.

The phone runs on Android 9.0 (Pie) + Android One.

Prerequisites & Preparation

  • Backup Data: Flashing will completely wipe all data on your device. Back up important files and settings before proceeding.
  • Battery Level: Ensure your device has at least 50% battery to prevent shutdown during the flashing process.
  • USB Driver & Tools: Install the correct USB drivers for your brand and prepare the flashing tool (Odin for Samsung, SP Flash Tool/QPST for Qualcomm/MTK, etc.).

CAUTION: Flashing official firmware carries a risk of bricking your device. Proceed with caution and at your own risk. addROM is not responsible for any damage caused to your device.

Download Stock ROM & Firmware

Global / General

File TypeFirmware / BuildRegion / ModelOS VersionDownload Link
Stock ROMNokia7.2Global / General–Google Drive
Stock ROMHMDSW_Nokia7.2_00WW_2_390_B01_QPST.rarGlobal / GeneralAndroid 2Google Drive
Stock ROMHMDSW_Nokia7.2_00WW_1_200_B01_devicekit_user.rarGlobal / GeneralAndroid 1Google Drive
Stock ROMHMDSW_Nokia7.2_00WW_1_130_B01_OS9_devicekit_user.rarGlobal / GeneralAndroid 1Google Drive

Additional Files & Tools

How to Flash Firmware / Stock ROM

To flash the stock firmware on your Nokia device using QFIL Tool, follow these steps:

  1. Download and install the Qualcomm USB Drivers on your computer.
  2. Download and install the QPST/QFIL Tool.
  3. Open QFIL and select Flat Build in the configuration.
  4. Browse and select the programmer file (usually .elf or .mbn) from the firmware folder.
  5. Click Load XML and select rawprogram0.xml, then select patch0.xml.
  6. Power off your device, hold the Volume Up + Volume Down buttons, and connect the USB cable to enter EDL Mode (Qualcomm HS-USB QDLoader 9008).
  7. Click the Download button to start the flashing process.

You may also like

Subscribe
Notify of
guest

0 Comments
Newest
Oldest Most Voted